New England Jeepz
General Category => Technical Discussion => Topic started by: Axle on July 21, 2015, 08:24:55 AM
-
going to fast and getting air is a bad thing. Should I weld this with my little Hobart 140 (110) or have someone with a big unit do it?
(http://i25.photobucket.com/albums/c79/axle05/cracked%20housing.jpg) (http://s25.photobucket.com/user/axle05/media/cracked%20housing.jpg.html)
-
Big machine, is the tube actually cracked or just the weld?
-
You could short term seal the leak with the 110 so as to not miss any wheeling
-
I would use the machine you have Bob, just make sure you prep the crack. Drill stop holes at each end, and grind a deep V into the crack.
-
I have a big unit
-
I was waiting for that lol
-
Too add to what Chuck said, I would spray the piss out of it with brake cleaner.
-
Thanks guys, one of the OSJ guys is near me, Ricky with the yellow 1 ton tj , he can do it for me I think. I really want a deep penetration from a big init. ;)
-
;D
-
Too add to what Chuck said, I would spray the piss out of it with brake cleaner.
Just be careful doing that because it lets off some nasty fumes
-
non chlorinated brake cleaner is cool. chlorinated cleaner is deadly when you when after.
-
all welded back together ;)
-
:cheers: