New England Jeepz
Vendors => Public Vendor Section => Topic started by: Hassan Auto on April 09, 2008, 07:38:53 PM
-
We are stripping a Blue 00 WJ 4.7 ltr. and a silver 00 XJ 4.0 auto. Not much left and will be going to the yard soon. If you need any parts let me know soon or they will be gone. Will take any offer on the parts left. Thanks.
-
any pictures of whats left to help give us an idea?
-
I'll have them up tomorrow.
-
Does the master/booster work in the WJ?
-
Yes, It is in good condition.
-
Front Seats? are they leather?
-
We only have passenger seats. One is dark grey and one is light grey. Both are power.
-
def hold that trackbar for me, ill get it when i can, sorry jeeptech i work all the time
-
Does the WJ have front tow hooks?
-
Here are the Jeeps we are stripping.
This one is going very soon, and best offer on anything left.
(http://render-2.snapfish.com/render2/is=Yup6aQQ%7C%3Dup6RKKt%3Axxr%3D0-qpDofRt7Pf7mrPfrj7t%3DzrRfDUX%3AeQaQxg%3Dr%3F87KR6xqpxQQQGxeJoxoPoxQQQGeJooPoGQlqpfVtB%3F*KUp7BHSHqqy7XH6gX0QPne%7CRup6G0G%7C/of=50,590,394)
This 92 YJ we are still picking appart.
(http://render-2.snapfish.com/render2/is=Yup6aQQ%7C%3Dup6RKKt%3Axxr%3D0-qpDofRt7Pf7mrPfrj7t%3DzrRfDUX%3AeQaQxg%3Dr%3F87KR6xqpxQQ0Gx0lPxlPJxv8uOc5xQQQGeJooPlJPGqpfVtB%3F*KUp7BHSHqqy7XH6gX0QPn0%7CRup6lQQ%7C/of=50,590,442)
99 WJ 4.0
(http://render-2.snapfish.com/render2/is=Yup6aQQ%7C%3Dup6RKKt%3Axxr%3D0-qpDofRt7Pf7mrPfrj7t%3DzrRfDUX%3AeQaQxg%3Dr%3F87KR6xqpxQQQGxeJoxoPoxQQQGeJooPoGQaqpfVtB%3F*KUp7BHSHqqy7XH6gX0QPne%7CRup6G0G%7C/of=50,590,394)
94 ZJ V-8
(http://render-2.snapfish.com/render2/is=Yup6aQQ%7C%3Dup6RKKt%3Axxr%3D0-qpDofRt7Pf7mrPfrj7t%3DzrRfDUX%3AeQaQxg%3Dr%3F87KR6xqpxQQQGxeJoxoPoxQQQGeJooPoGPQqpfVtB%3F*KUp7BHSHqqy7XH6gX0QPan%7CRup6G0G%7C/of=50,590,394)
97 ZJ V-8 blown engine
(http://render-2.snapfish.com/render2/is=Yup6aQQ%7C%3Dup6RKKt%3Axxr%3D0-qpDofRt7Pf7mrPfrj7t%3DzrRfDUX%3AeQaQxg%3Dr%3F87KR6xqpxQQQGxeJoxoPoxQQQGeJooPoGPoqpfVtB%3F*KUp7BHSHqqy7XH6gX0QPnl%7CRup6G0G%7C/of=50,590,394)
97 XJ
(http://render-2.snapfish.com/render2/is=Yup6aQQ%7C%3Dup6RKKt%3Axxr%3D0-qpDofRt7Pf7mrPfrj7t%3DzrRfDUX%3AeQaQxg%3Dr%3F87KR6xqpxQQQGxeJoxoPoxQQQGeJooPoGaoqpfVtB%3F*KUp7BHSHqqy7XH6gX0QPnG%7CRup6G0G%7C/of=50,590,394)
78 CJ-7 Very rotted good 4.2
(http://render-2.snapfish.com/render2/is=Yup6aQQ%7C%3Dup6RKKt%3Axxr%3D0-qpDofRt7Pf7mrPfrj7t%3DzrRfDUX%3AeQaQxg%3Dr%3F87KR6xqpxQQQGxeJoxoPoxQQQGeJooPoGalqpfVtB%3F*KUp7BHSHqqy7XH6gX0QPna%7CRup6G0G%7C/of=50,590,394)
00 XJ Blown engine, this one is going very soon. best offer on any parts left.
(http://render-2.snapfish.com/render2/is=Yup6aQQ%7C%3Dup6RKKt%3Axxr%3D0-qpDofRt7Pf7mrPfrj7t%3DzrRfDUX%3AeQaQxg%3Dr%3F87KR6xqpxQQQGxeJoxooGxQQQGeJoooGJJaqpfVtB%3F*KUp7BHSHqqy7XH6gX0QPno%7CRup6G0G%7C/of=50,590,394)
-
Windshield with hinges from the YJ, Tail gate with hinges from the CJ if there is a 23 spline 231 in the yj, that to.
-
actually, I bet I know where that T case went if it is gone
-
wj knuckles calipers rotors? pm me!
-
zj tie rod?
-
I need a zj tie-rod set-up too, pm me if you have one for me.
-
how much for the header panel off one of the xjs? the front piece that has the jeep emblem
-
I have one that has a crack in the lower right corner nothing bad, It's green $40
-
Do you have any TJ interior parts? There are 4 things I'm looking for:
1: The plastic strip on the inside/top of the windshiel which holds the windshield visors
2: The plastic part on the bottom of the shifter boot which connects it to the console
3: (X2)Switch bezels from a 97-02 TJ with 3 switches + 1 cigarette lighter
4: (X3 or 4)Factory fog light switches w/wiring connector
-
Tooch, We don't have the plastic strip or the shifter boot retainer. I do have one switch bezel W/lighter but no good used fog light switches, have new ones though.
-
What's the price tags on them?
-
Hey Chris, know you busy, wondering how that price for the windshield frame, hinges and t-case is doing?
-
John, sorry. The tail gate is bondoed to the body so it's not coming off in good shape. $100 for the windshield frame with hinges. Do you want a complete T-case or just parts? I know I talked to you about parts before. I still have a box of T-case parts if you want them.
-
this one needs to be a complete 23 spline case
-
Jeeptech-
How much for the drivers side front seatbelt assembly from the 1992 YJ?
-
I found the part I needed in my parts cherokee. Thanks anyways!!
-
Great Parts, excellent prices. Thanks again...shop again soon!
-
Im looking for a working fog light switch and a rear wiper switch for a 97+ XJ if one of them has those in it. Thanks!
-
Yes, we have both switches. $10 ea.
-
how about the whole heater cluster, my heat works but only on high, i believe its the switch
-
how about the whole heater cluster, my heat works but only on high, i believe its the switch
you need a blower motor resistor switch probably, might be the controls, not too sure with jeeps.
-
Bob, you need a blower motor resistor. Sometimes the connector melts @ the resistor so check it good.
-
Hey jeeptech do you have any used Cherokee gas tanks that would fit a 1990 XJ?
-
Thanks for the tank Chris!! 8)
-
Chris, do you have speedo gears? I need a 28 tooth grear. 2005 TJ 3.73 gears, 6 speed manual 36" TSLs. I have a 34 in there now, tried a buddies 30 tooth from his 99 and the gear was a lot smaller. Should It be the same diameter just different tooth count? also do I need to change the spiral gear that sits on the t-case output shaft?
-
You need to rotate the sending unit in the hole (thats why the speedo gear is not centered in it) depending on the size gear. The older housings have tooth counts stamped into the plastic for reference.
-
So rotating it will push it further in to allow it to still contact the gear inside the tcase?
-
I will look for the 28 tooth and let you know. The housing has a # range cast into it and the speedo gear has a # on the under side. both # have to match up and you rotate the housing to lineup the #'s. Chris.
-
chris, any luck on the 28 tooth speedo gear? I got the 30 to work, figured out the housing with Krome but its still off by about 5 mph on the highway. Also Im looking for a Downpipe/dual cat setup for a 2005 TJ 4.0. I had a check engine light with code 431 bad catalyst warmup, thought it was the leak I had, fixed that, code came back, replaced both O2 sensors on that bank, light came back. Next step is the cats I guess.
-
Sorry, I didn't look yet for the gear, I will get on it. I Don't have A cat/headpipe. I have one for a Cherokee, but it is different it could be modified. That pipe is under warranty for 8 yrs- 80Kmi. Are you still under that?
-
I am still under powertrain (approx 53K on it now) had the cats and O2 sensors replaced under warranty at 30K because of an engine code. Problem came back at around 42K. I was told that becuase of my aftermarket exhaust (glass pack after the 3rd cat, now aftermarket cat and flowmaster muffler) The exhuast will no longer be covered. According to the dealership my modifications to the exhaust has caused the problems. Is there a way I can fight them on that or do they have a good argument against me?
-
jj is talking about the two cats on the exhaust manifold, the bank 2 cat is failing. not the 3rd converter that he just replaced due to space of high clearance exhaust. figured id clear it up, those upper cats are factory so SHOULD still be covered, but dealerships love the drama
-
jj is talking about the two cats on the exhaust manifold, the bank 2 cat is failing. not the 3rd converter that he just replaced due to space of high clearance exhaust. figured id clear it up, those upper cats are factory so SHOULD still be covered, but dealerships love the drama
thanks Krome, the parts guy at the local dealership even said that theres no reason for them to not cover the small cats. Maybe a visit with the owner will help.
-
federal emission vehicle don't have the third cat. So I don't know how the performance exhaust wii cause a failure. Only A restriction would cause a failure in the cats.
-
federal emission vehicle don't have the third cat.
Found it!
(http://i95.photobucket.com/albums/l145/jps4jeep/ThreeCats_jpg.jpg)
Problem solved!
Sorry couldn't help myself
-
hahaha. I guess jeep changed something that worked fine. Did I mention I hate emissions control?
-
Chris, looking for a MPI YJ fuel pump assembly and flange plate.
If you have Just the flange plate, that would work too, won't need the pump assemblly for a while.
-
John, Are you just looking for the reinforcement plate that bolts to the top of the sender? I don't have a sender out, but I do have a bunch of plates. When I pull the tank I will let you know.
-
that plate will be fine, just need it to cut and mock up some type of flange for my cell.
-
I have a bunch, so if you need more than one I have them.
-
any chance you have a black/agate 96-98 zj style steering wheel that isnt worn on the top? mine finally wore thru and will bother the hell outta me till i replace it.
-
I have two. I need to check the condition of them and I will get back to you.
-
Beautiful, thank you.